SWITCHING POWER ON/ OFF
Press [ ] to switch the transceiver ON.
Press [ ] again to switch the transceiver OFF.
Transceiver Password
If the Transceiver Password function is programmed, "PS" will appear on the
display when the power is turned ON.
To enter the password:
1 Press
/
•
When using an optional microphone with a keypad, simply enter the
password digits and proceed to step 3.
2 Press S or
•
Press A or # to delete an incorrect digit. Press and hold A or # to delete all
digits.
•
Repeat steps 1 and 2 to enter the entire password.
3 Press S or
•
If you enter an incorrect password, the transceiver remains locked.
ADJUSTING THE VOLUME
Press the key programmed as [Volume Up] to increase the volume. Press the
key programmed as [Volume Down] to decrease the volume.
SELECTING A ZONE AND CHANNEL
Select the desired zone and channel using the keys programmed as [Zone Up]/
[Zone Down] and [Channel Up]/ [Channel Down].
•
"G1" (Zone 1)/ "16" (Channel 16) appears on the display.
TRANSMITTING
1 Select the desired zone and channel.
2 Press the key programmed as [Monitor] or [Squelch Off] to check whether or
not the channel is free.
•
If the channel is busy, wait until it becomes free.
3 Press the PTT switch and speak into the microphone. Release the PTT switch
to receive.
•
For best sound quality at the receiving station, hold the microphone
approximately 1.5 inches (3 cm to 4 cm) from your mouth.
BASIC OPERATION
to select a digit.
to accept the entered digit and move to the next digit.
to confirm the password.
15