Removing A Pdu - Cisco ASR 14000 Series Installation Manual

Chapter 2 Installing and Removing Power Components
Are there comparable ASR 14000 parts and product numbers?
Steps
To install a PDU, follow these steps:
Attach the ESD-preventive wrist strap to your wrist and connect its leash to one of the ESD connection
Step 1
sockets on the rear (MSC) side of the chassis or a bare metal surface on the chassis.
Make sure that the PDU is unplugged.
Step 2
Grasp the PDU by the side and set it carefully into place in a PDU slot on the rear (MSC) side of the
Step 3
chassis. Be sure to lift the PDU over the lip on the edge of the chassis, and align the guide pins on the
chassis with the guide holes on the PDU.
Do not lift the PDU by the power cord—doing so can damage the PDU or the cord.
Caution
If needed, put the second PDU into place in the other PDU slot on the chassis.
Step 4
Note
Install the PDU holding plate.
Step 5
a.
b.
c.
Use the socket wrench to install the 8-mm center holding bolt and the 10-mm nut.
Step 6
What to Do Next
After performing this task, install the power modules (see the
page

Removing a PDU

This section describes how to remove a PDU in the Cisco ASR 14000 series 8-slot line card chassis. For
information on the difference between the power types, see the
and the
and safety, see Regulatory Compliance and Safety Information for the Cisco ASR14000 Series
Aggregation Services Router.
OL-16973-01
AC Wye PDU Cisco product number ASR14K/8-ACW-KIT=
–
AC Delta PDU Cisco product number ASR14K/8-ACD-KIT=
–
DC PDU Cisco product number ASR14K/8-DC-KIT=
–
The PDU holding plate bolts to both PDUs and the side of the interior of the chassis.
Slide the holding plate into place on top of the PDU, using the guide bolts on the side of the chassis
to place it correctly.
Use the socket wrench to bolt the holding plate to the top of the PDUs with the eight 10-mm bolts
(four for each PDU).
Use the socket wrench to bolt the holding plate to the interior of the side of the chassis with the four
8-mm bolts (two for each side)
2-13), and replace any cosmetic covers.
"AC Power Systems" section on page 2-8. For complete information on regulatory compliance
Cisco ASR 14000 Series Router 8-Slot Line Card Chassis Installation Guide
How to Install or Remove the Power Components
"Installing a Power Module" section on
"DC Power Systems" section on page 2-4
2-11