Table of Contents
Advertisement
Converting the system from tower mode to rack
mode
Your system can be converted from tower mode to rack mode.
To convert your system from tower mode to rack mode, you require the tower-to-rack conversion kit, which contains the following
items:
•
Rack ears (left and right) with three screws each
•
VGA module included with the control panel for rack mode
•
A pair of rails (optional)
Safety instructions for converting system from tower to rack
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support
team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety
instructions that came with the product.
CAUTION: Do not attempt to convert your system into a rack unless authorized by Dell. Only customers certified by Dell
for tower to rack conversion can convert a tower system into a rack system.
NOTE: For specific caution statements and procedures, see the rack installation documentation for your system at
Dell.com/poweredgemanuals. For complete safety and regulatory information, see the safety instructions that shipped
with your system.
Observe the following precautions for stability and safety of the system in rack mode:
•
Before installing your equipment in a rack, install the front and side rack stabilizers. Failure to install the stabilizers can cause the
rack to tip over.
•
Always load from bottom up, and load the heaviest items first.
•
Do not overload the AC power supply branch circuit that provides power to the rack.
Preparing a system for conversion from tower mode to rack mode
Prerequisites
1.
Ensure that you follow the safety instructions for converting system from tower to rack.
2.
Keep the Phillips #2 screwdriver ready.
3.
Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.
4.
Place the system on a flat and stable surface.
5.
If installed, remove the system feet or caster wheels.
6.
Remove the system cover.
Steps
1.
Remove the control panel assembly from the chassis.
2.
Remove the control panel assembly cover.
7
149
Advertisement
Table of Contents
Troubleshooting
