Running Configuration Settings - Cisco 12404 Installation And Configuration Manual

Chapter 3 Installing the Cisco 12404 Internet Router

Running Configuration Settings

show running Config Command Example
OL-11636-01
1 Route Processor Card
2 Clock Scheduler Cards
5 Consolidated Switch Fabric Cards
2 OC48 POS controllers (2 POS).
1 four-port OC48 POS controller (1 POS).
1 Ethernet/IEEE 802.3 interface(s)
6 Packet over SONET network interface(s)
507K bytes of non-volatile configuration memory.
8192K bytes of Flash internal SIMM (Sector size 256K).
Configuration register is 0x0
...
Filo#
You can check the running configuration settings or any changes you made to the
settings before you save them. Enter the show running-config command at the
privileged EXEC mode prompt.
For a Quad OC-3c/STM-1c POS interface installed in slot 1, the show
running-config command typically displays output in the following form.
Depending on the image version of the Cisco IOS software running on your
Cisco 12404 router and the way it is equipped, the results of your show
running-config command might be different.
router# show running-config
Building configuration...
Current configuration:
!
version 12.0
no service pad
no service udp-small-servers
no service tcp-small-servers
!
hostname Filo
!
enable secret 5 $1$W6K5$W/p5Bq6IPLGJ/hS9VVP1g.
Cisco 12404 Internet Router Installation and Configuration Guide
Configuration Changes
3-66