Replacing A Fan Module; Finding The Fan Module Serial Number - Cisco Catalyst 2360 Hardware Installation Manual

Hide thumbs Also See for Catalyst 2360:

Table of Contents

Chapter 3

Power Supply and Fan Module Installation

Replacing a Fan Module

See a video demonstration of the fan installation here:

Note

http://www.cisco.com/en/US/prod/collateral/switches/ps5718/ps10920/vds_cis_108148_cat2360_fan_i

nstallation.html

Do not reach into a vacant slot or chassis while you install or remove a module or a fan. Exposed

Warning

circuitry could constitute an energy hazard. Statement 206

Step 1

Using a flat blade screwdriver, loosen the captive screw.

Step 2

Grasp the captive screw, and pull out the fan module.

Caution

Replace a failed fan module before a CLI message shows that the switch is overheating (approximately

5 minutes).

Align the air flow direction indicator on the fan module with one of the direction indicators on the switch

Step 3

chassis (Figures 3-7 through 3-10) and push the module into the slot. When correctly inserted, the fan

module is flush with the switch rear panel.

Fasten the captive screw. When the fan is operating, the fan LED on the switch front panel is green.

Step 4

The switch continues to operate when one fan fails. If one fan fails, the Fan LED turns amber. If the

second fan fails, the switch sends an error message, writes a failure log to flash memory, and shuts down.

If you contact Cisco Technical Assistance regarding a fan module, you need to know the serial number.

Figure 3-11

OL-22150-02

shows the serial number location.

Catalyst 2360 Switch Hardware Installation Guide

3-9

Table of Contents