Installing A Cxp Module - HP FlexFabric 12900E series Installation Manual

Figure 36 Installing a CFP2 module (12916E switch)
For information about connecting an optical fiber, see

Installing a CXP module

CAUTION:
• Read the following instructions before you install a CXP module. Failure to follow these
instructions might cause damage to the CXP module.
• Do not remove the dust plug from the CXP module if you are not to connect an optical fiber to the
module.
• Before you install a CXP module, remove the optical fiber (if any) from it.
CXP modules are available in two types. One type is with a rubber pull latch and the other is with a
plastic pull latch.
The installation and removal procedures are the same for the CXP modules with a rubber or plastic
pull latch. This guide uses the CXP module with a plastic pull latch as an example.
To install a CXP module:
1
2
46
"Connecting your switch to the network."