Removing A Filler Panel From A Switching Fabric Module Slot - HP FlexFabric 12900E series Installation Manual

Figure 27 Installing a filler panel in a switching fabric module slot (12916E switch)
(1) Push the filler panel slowly into the slot
(3) Fasten the captive screws on the ejector levers

Removing a filler panel from a switching fabric module slot

As shown by callout 1 in
1.
As shown by callout 2 in
2.
part way out of the slot.
As shown by callout 3 in
3.
filler panel out of the slot.
Keep the removed the filler panel secure for future use.
(2) Simultaneously rotate the ejector levers inward
Figure 28, loosen the captive screws on the ejector levers.
Figure 28, rotate outward the ejector levers. Then pull the filler panel
Figure 28, hold the filler panel by the top and bottom edges to pull the
38