Honeywell GSMVLP4G Installation And Programming Manual page 19

GSMVLP4G Status Displays (Continued)
[E]
PriRSSI
-xxxdbm
RAT
2G
CNtry NetW
xxx xxx
Cell BaseSt
xxxx xx
Second Site
Available
GSMVLP4G Status Display Screen 1
2G REG
(4G Radio operating with 2G Service)
stat x
PriRSSI – Primary Site RSSI level in dbm
2G – Radio module is communication on the 2G Network
where "stat" can be:
Good
OK
Marginal RSSI -99 to -104 dbm
Bad
REG – Registration status from radio module where "x" can be:
N – Not Registered
H – Registered Home
S – Searching
D – Registration Denied
R – Registered Roaming
? – Unknown Registration State
Press the [space] key to go to the next screen.
Press the [backspace] key to go to the last screen.
GSMVLP4G Status Display Screen 2
EC/NO
(4G Radio operating with 2G Service OR 2G Radio)
NA
RAT – Radio Access Technology. Either 2G OR 3G/4G
EC/NO – Carrier Noise Ratio (CNR) (not a 2G parameter – NA
will be displayed)
Note: If a 2G radio is installed this display will not appear.
Press the [space] key to get to the next screen.
Press the [backspace] key to go to the previous field.
GSMVLP4G Status Display Screen 3
LAC
(4G Radio operating with 2G Service OR 2G Radio)
xxxxx
CNtry – Country Code
NetW – Network Code
LAC – Local area code
Press the [space] key to get to the next screen.
Press the [backspace] key to go to the previous field.
GSMVLP4G Status Display Screen 4
Chan
(4G Radio operating with 2G Service OR 2G Radio)
xxx
Cell – Base Station ID
BaseSt – Base Station Antenna Sector
Chan – Control Channel in use
Press the [space] key to go to the next screen.
Press the [backspace] key to go to the previous field.
GSMVLP4G Status Display Screen 5
RSSI
(4G Radio operating with 2G Service OR 2G Radio)
Secondary Site RSSI availability. The system displays Available
or Not Available.
Press the [space] key to go to the GSMVLP4G Status Display
Screen 1.
Press the [backspace] key to go to the previous field.
– 19 –
RSSI -20 to -89 dbm
RSSI -90 to -98 dbm
RSSI -105 to -150 dbm