90 Control panels
Initially, the panel is in the Output mode, where you can
start, stop, change the direction, switch between local and
remote control, modify the reference value and monitor up
to three actual values.
To do other tasks, go first to the Main menu and select the
appropriate mode on the menu. The status line (see
section
Status line
current menu, mode, item or state.
How to do common tasks
The table below lists common tasks, the mode in which you can perform them and
the page number where the steps to do the task are described in detail.
Task
How to get help
How to find out the panel version
How to adjust the display contrast
How to switch between local and remote control
How to start and stop the drive
How to change the direction of the motor rotation
How to set the speed, frequency or torque reference
How to change the value of a parameter
How to select the monitored signals
How to do guided tasks (specification of related parameter sets)
with assistants
How to view and edit changed parameters
How to view faults
How to reset faults and alarms
How to show/hide the clock, change date and time formats, set the
clock and enable/disable automatic clock transitions according to
the daylight saving changes
How to copy parameters from the drive to the control panel
How to restore parameters from the control panel to the drive
How to view backup information
How to edit and change parameter settings related to I/O terminals I/O settings
on page 89) shows the name of the
LOC
49.1Hz
49 1 Hz
.
0 5 A
.
10 7 %
.
00:00
DIR
MENU
LOC
MAIN MENU
PARAMETERS
ASSISTANTS
CHANGED PAR
00:00
EXIT
ENTER
Mode
Page
Any
At power up
Output
Any
Any
Output
Output
Parameters
Parameters
Assistants
Changed
parameters
Fault logger
Output, Fault
Time and date
Parameter
backup
Parameter
backup
Parameter
backup
1
91
91
94
92
93
93
94
95
96
98
100
101
335
102
105
105
106
107