Makita BPT350 Technical Information page 6

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -5. Spring Section (cont.)
DISASSEMBLE
3) Disassemble the Spring section in order from Fig. 19 to Fig. 22. Spring section is removed as illustrated in Fig. 23.
Fig. 19
Wrench 8
Turn guide bolt counterclockwise
while gripping holder by a gloved
hand.
M6 hex nut, Holder with Rail and
Flat washer 6 are removed from
Guide bolt.
Fig. 21
Turn compression spring 17 counterclockwise while
holding Spring holder with gloved hands.
Spring holders is removed from Compression spring 17.
Fig. 23
Holder Rail
Hex
Nut
Spring holder
Guide bolt
Rail
Holder
Hex
Nut M6
Compression
spring 17
Spring holder
Cushion
Flat washer 6
Compression spring 17
Fig. 20
Cushion
Flat
Washer 6
Fig. 22
Flat washer 8
Guide bolt
After removing Guide bolt and Flat washer 8, remove
Spring holder of the opposite side in the same way
illustrated in Fig. 21.
Note: When inserting Spring holder into Compression
spring 17, turn Compression spring 17 clockwise
and twist Spring holder to set in place.
Hammer
Flat washer 8
Spring holder Guide bolt
Guide bolt
Cushion
Hammer
Cushion is fit into the groove of Guide
bolt firmly. Therefore, twist Cushion to
pull it off from the groove.
P 6/ 13
Spring
holder