Lcd - Hitachi IJ UX Service Manual

3.2.3 LCD

[Function]
- The LCD panel for screen display.
[Note at the replacement]
- Be sure to turn off the power when replacing the panel.
- After replacing, insert the flexible flat cable that connects the LCD to EZJ128 board to
right places.
[Note at the insertion and extraction of flexible flat cable (hereinafter referred as FFC)]
(1) How to unlock
Press the actuator upward (Figure 1).
*Use your fingernails of thumb or forefinger and handle the actuator like flipping it
upward.
Figure 1
Actuator
Do not unlock the actuator by picking up with fingers or do not use tools such as driver
to unlock actuator as shown in figure 2. These may lead to a breakage of the actuator.
(2) How to insert the FFC
Insert the FFC with its contact surface facing down. Also insert the FFC in a direction
perpendicular to the connector. (Figure 3)
Figure 3
Insert the FFC in a direction perpendicular to the connector. Incorrect insertion like
shown in figure 4 could cause conduction failure or breakage of the actuator.
！ Caution when unlocking the actuator
Contact surface
Caution when inserting FFC
!
3-10
Figure 2
Tools such as driver
Figure 4