Oven Sensor; Bake Element; Broil Element; Ribbon Elements - Maytag AER4311AAW Service Manual

Disassembly Procedures
!

Oven Sensor

1. Disconnect power before servicing.
2. Open oven door and remove screws securing sensor
to oven cavity.
NOTE: Gently pull wiring through cavity wall.
3. Disconnect oven sensor at the connector terminal
and remove.
4. Reverse procedure to reinstall sensor.
NOTE: Verify connection is pushed through the
insulation.
Oven Sensor

Bake Element

1. Turn power off.
2. Remove screws securing bake element to rear of
oven wall.
3. Pull element forward to allow disconnection of
terminals on each element leg.
4. Reverse procedure to reinstall bake element.

Broil Element

1. Turn power off.
2. Remove screws securing broil element to top and
rear of oven cavity.
3. Pull broil element forward to allow disconnection of
terminals on each element leg.
4. Reverse procedure to reinstall broil element.

Ribbon Elements

1. Remove maintop assembly, see "Maintop Assembly"
procedure.
2. Remove screws securing element support bracket to
maintop.
3. Label and disconnect wire terminals from element
being replaced.
4. Release metal clips securing element to element
support bracket.
5. Replace and reverse procedure to reinstall element.

Coil Element Terminal

1. Remove maintop assembly, see "Maintop Assembly"
procedure.
2. Remove screw securing element support bracket to
maintop.
3. Label and disconnect wire terminals from element
being replaced.
©2004 Maytag Services
WARNING
To avoid risk of electrical shock, personal injury or
death; disconnect power to unit before servicing.

Manual Oven Door Latch Assembly

1. Remove maintop assembly, see "Maintop Assembly"
procedure.
2. Remove screws securing latch assembly to the front
of the oven cavity outer shell.
3. Label and disconnect wire terminals from latch
assembly.
4. Reverse procedure to reinstall door latch assembly.

Oven Door Removal

To avoid risk of personal injury or property damage,
do not lift oven door by the handle.
1. Open oven door slightly and grasp door on both
sides.
2. Lift up and off the hinge receivers.
3. Reverse procedure to reinstall oven door.

Oven Door Hinge Receiver

1. Turn off power to unit.
2. Remove oven door, see "Oven Door Removal"
procedure.
3. Remove maintop assembly, see "Maintop Assembly"
procedure.
4. Remove side panel, see "Side Panel Removal"
procedures.
5. Remove storage/warming drawer, see "Storage
Drawer Removal" or "Warming Drawer Removal"
procedure.
6. Remove the top and bottom screws securing hinge
receiver to the front frame.
7. Remove hinge receiver from oven chassis.
8. Reverse procedure to reinstall oven door hinge
receiver.

Side Panel Removal

1. Turn power off.
2. Remove oven door, see "Oven Door Removal"
procedure.
3. Remove maintop assembly, see "Maintop Assembly"
procedure.
4. Remove screws securing lower rear galvanized cover
from unit.
5. Remove screws securing top and back of side panel.
6. Pull rear of side panel away from range then slide
side panel forward to release from side panel
spacers.
7. Reverse procedure to reinstall side panel.
16023528
!
WARNING
19