Cisco 350XG series Administration Manual page 322

IP Configuration
IPv4 Management and Interfaces
STEP 4
STEP 5
STEP 6
STEP 7
!
CAUTION
Cisco 350XG & 550XG Series 10G Stackable Managed Switches
- Delayed—The assignment of the IP address is delayed for 60 second if
DHCP Client is enabled on startup in order to give time to discover DHCP
address.
- Not Received—Relevant for DHCP Address. When a DCHP Client starts
a discovery process, it assigns a dummy IP address 0.0.0.0 before the
real address is obtained. This dummy address has the status of "Not
Received".
Click Add.
Select one of the following fields:
• Interface—Select the port, OOB port, LAG, Loopback or VLAN as the
interface associated with this IP configuration, and select an interface from
the list.
• IP Address Type—Select one of the following options:
- Dynamic IP Address
Static IP Address
-
• IP Address—Enter the IP address of the interface.
If Static IP Address was selected, enter the Mask field:
• Network Mask—IP mask for this address.
• Prefix Length—Length of the IPv4 prefix.
Click Apply. The IPv4 address settings are written to the Running Configuration
file.
When the system is in one of the stacking modes with a Backup Master present,
Cisco recommends configuring the IP address as a static address to prevent
disconnecting from the network during a Stacking Master switchover. This is
because when the backup master takes control of the stack, when using DHCP, it
might receive a different IP address than the one that was received by the stack's
original master-enabled unit.
—Receive the IP address from a DHCP server.
—Enter the IP address.
16
311