Installing Cisco TelePresence MX200 - Table Stand
1b
Unpacking the MX200 video system
The MX200 box
The MX200 box contains the LCD video unit, the Touch
controller and accessories.
i
Cut the straps and lift off the outer covering.
ii
Remove the upper foam protection.
Note:
Leave the LCD video unit in the bottom tray
for now.
iii
Lift out the rectangular box from behind the LCD
video unit.
This box contains two smaller boxes: One with the
Touch controller and one accessories box with the
microphone, cables, screws and tool.
iv
Unpack the Touch controller, and open the
accessories box.
78-20007-03 MX200 Table Stand Installation Sheet | 2012 JANUARY | © 2011-2012 Cisco Systems, Inc. All rights reserved.
Outer
covering
LCD video
unit
Bottom tray
Touch controller
with cable
Accessories box:
•
Microphone
•
Power cable
•
Presentation cable (VGA to
DVI-I; stereo audio)
•
Ethernet cable
•
Four screws for fastening
the LCD video unit to the
table stand
•
Hexagonal screwdriver
•
Two pairs of gloves