Cisco SCH-7IN-TS-B/W Reference Manual page 19

With both hands, tilt the bottom of the touchscreen out and gently remove the touchscreen.
Step 3
On the back of the touchscreen locate the small switch (see
Step 4
Figure 16
Step 5 Using the tip of a straight pin or paper clip, change the position of the switch, for example, if the switch
is in the down position, push it to the up position. The touchscreen will then sense the change on the next
power up, and will initiate the restore process.
When you are finished with the restore, reattach the touchscreen into the power box in the wall— top
Step 6
first—and then snap the bottom of the touchscreen back into place.
The touchscreen will reboot and the factory default firmware image will be installed. All settings will
Step 7
reset to the factory default settings. See the
how the LED behaves during a factory restore.
After a restore, the touchscreen will need to be updated to the same image version of the project (e.g.,
Step 8
OS 2.2.2 or later).
OL-27263-01
Factory Restore Switch
Cisco Smart+Connected 7" In-wall Display Reference Guide
Figure 16).
"LED Indicator" section on page 8
Restore to Factory Default
for information about
19