Managed Ap Advanced Settings; Figure 374: Advanced Ap Management; Table 343: Advanced Ap Management - D-Link DWL-8600AP User Manual

D-Link UWS User Manual

Managed AP Advanced Settings

When the AP is in Managed mode, remote access to the AP is disabled. However, you can enable Telnet access
by enabling the Debug feature on the AP Management > Advanced Settings page. From the Managed AP
Advanced Settings page, you can also manually change the RF channel and power for each radio on an AP. The
manual power and channel changes override the settings configured in the AP profile (including automatic
channel selection) and take effect immediately. The manual channel and power assignments are not retained
when the AP is reset or if the profile is reapplied to the AP, such as when the AP disassociates and reassociates
with the switch.
Each AP managed by the DWS-4000 Series switch is listed by its MAC address and location. The location is
based on the value in the RADIUS or local Valid AP database.
can configure for the AP.
Field
MAC Address
Location
Debug
Radio
Channel
D-Link
Oct. 2015

Figure 374: Advanced AP Management

Table 343: Advanced AP Management

Description
Shows the MAC address of the AP.
Shows the AP location, which is based on the value configured in the RADIUS or local
Valid AP database.
To help you troubleshoot, you can enable Telnet access to the AP so that you can
debug the device from the CLI.
The Debug field shows the debug status and can be one of the following:
• Disabled
• Set Requested
• Set in Progress
• Enabled
To change the status, click the Debug status link. The Managed AP Debug page
appears. Table 344 describes the fields on the new page.
Identifies the radio to which the channel and power settings apply.
Click the Channel link to access the Managed AP Channel/Power Adjust page. From
that page, you can set a new channel for Radio 1 or Radio 2. The available channels
depend on the radio mode and country in which the APs operate. The manual
channel change overrides the channel configured in the AP profile and is not retained
when the AP reboots or when the AP profile is
describes the fields on the new page.
Table 343 describes the Advanced features you
reapplied.Table 345 on page 589
Unified Wired and Wireless Access System
AP Management
Page 586