Controller Setup - Cisco 2100 Series Configuration Manual

Spectralink VIEW Certified Configuration Guide: Cisco Controllers and APs
2 In the navigation pane, click Summary. The heading labeled Software Version shows the
current software version.
3 Download the appropriate software for your model of controller from the Cisco website.
4 Set up a Trivial File Transfer Protocol (TFTP) server running on a PC to download the
file to the controller.
5 From the main menu, click Commands.
6 In the navigation pane, click Download File.
7 Fill in the download parameters:
a For File Type, select Code.
b For TFTP Server, type in the IP Address of the TFTP server.
Add the File Path (this is the path in the TFTP server's root directory and not the
c
system path where the TFTP server is located) and File Name of the firmware file to
download.
Note
The example simply uses the /designator for the root TFTP directory.
8 Point the TFTP server to the code.
9 Click Download and allow a few minutes for the download to complete.
10 Reboot the Controller.

Controller Setup

The initial setup of the controller is shown below.
Note: Example only
The setup instructions outlined in this document are for the configuration shown in the
diagram only. Your configuration may differ, and the appropriate adjustments must be
made.
721-1001-000-AH.docx
December 2016 12