4.
Remove switch disabling key, as shown in
Figure 43.
Figure 43. Removing switch key from paddle
switch.
5.
Try to start machine with paddle switch. The
machine should not start.
— If the machine does not start, the switch
disabling feature is working as designed.
Congratulations! The test run is complete.
Proceed to Recommended Adjustments.
— If the machine does start, immediately stop
the machine. The switch disabling feature
is not working correctly. This safety fea-
ture must work properly before proceeding
with regular operations. Call Tech Support
for help.
-30-
Recommended
Adjustments
For your convenience, the adjustments listed
below have been performed at the factory and no
further setup is required to operate your machine.
However, because of the many variables involved
with shipping, we recommend that you at least
verify the following adjustments to ensure the best
possible results from your new machine.
Step-by-step instructions for these adjustments
can be found in SECTION 7: SERVICE.
Factory adjustments that should be verified:
1.
Knife Settings (Page 45).
2.
Depth Scale Calibration (Page 49).
3.
Fence Stop Accuracy (Page 50).
4.
Table Parallelism (Page 53).
Model G0813/G0814 (Mfd. Since 3/16)