Lubrication - Grizzly G0813 Owner's Manual

Lubrication

Since all bearings are sealed and permanently
lubricated, simply leave them alone until they
need to be replaced. DO NOT lubricate them.
It is essential to clean components before lubri-
cating them because dust and chips build up on
lubricated components and make them hard to
move. Simply adding more grease to them will not
yield smooth moving components.
Clean the components below with mineral spirits
or other oil/grease solvent cleaner and shop rags.
Outfeed Table Leadscrew
Oil Type ................SB1365 or ISO 68 Equivalent
Oil Amount ............................................Thin Coat
Frequency .......................................... As Needed
Lubricate the outfeed table leadscrew with light
machine oil as needed (see Figure 62). Wipe off
excess oil and sawdust with a cloth.
Figure 62. Leadscrew lubrication location.
SB1365—South Bend Way Oil-ISO 68
Figure 63. Recommended product for machine
lubrication.
-42-
Table Ways
Oil Type .... Grizzly T23962 or ISO 68 Equivalent
Oil Amount ...........................................1–2 Drops
Lubrication Frequency ....................... As Needed
Lower infeed and outfeed tables to access ways.
Place a couple of drops of oil at top of each way
as needed, and move tables up and down to dis-
tribute oil (see Figure 64). Wipe off excess oil.
Figure 64. Location to lubricate table ways.
Fence
Oil Type .... Grizzly T23962 or ISO 68 Equivalent
Oil Amount ...........................................1–2 Drops
Lubrication Frequency ....................... As Needed
Place one or two drops of light machine oil on
fence pivot points (see Figure 65) as needed.
Figure 65. Fence lubrication locations.
Model G0813/G0814 (Mfd. Since 3/16)