Time Signals - Configuration Summary; Table 12: Summary Of All Configurable Parameters For Outputs - GE Reason RT430 Technical Manual

Charter 6 – Configuration

Time Signals - Configuration Summary

RT430/434
%s 'S' or '_'
%o '_' or '#'
%O '_' or '*'
%Q '_' or '?'
%1 <SOH>
%2 <STX>
%3 <ETX>
%4 <LF>
%5 <CR>
%x
%% '%'
'_' is the character 'blank (ASCII 32).
Checksum type 1 consists of two hexadecimal digits, which represent the result of a
XOR from all characters comprised between `\$' and `*' (`\$' e `*' not included). It is
useful for NMEA datagrams.
One example of serial datagram is presented below:
''Day:%d;Month:%m;Year:%Y;Hour:%H;Minute:%M;Second:%S;;%3''
The table below presents all configurable parameters for the time synchronization
outputs.

Table 12: Summary of all configurable parameters for outputs

Output TTL 1 / 2
Output OPTO 1 / 2
Output OC 1 / 2
1 DST ('S' if DST '_' in odder case)
1 Status ('_' if locked, '#' in odder case)
1 Status ('_' if locked, '*' in odder case)
1 Status ('_' if locked, '?' in odder case)
1 Start-of-header (ASCII 01)
1 Start-of-text (ASCII 02)
1 End-of-text (ASCII 03)
1 Line feed (ASCII 10)
1 Carriage returns (ASCII 13)
2 Checksum type 1
1 Character '%' (ASCII 37)
Outputs
Signal: OFF, PPS, 100PPS, PPX, PPM, TMARK, DMARK,
IRIG-B or DCF77
Polarity: normal or inverted
Signal: OFF, PPS, 100PPS, PPX, PPM, TMARK, DMARK,
IRIG-B or DCF77
Polarity: normal or inverted
Signal: OFF, PPS, 100PPS, PPX, PPM, TMARK, DMARK,
RT430/434
53