Troubleshooting - Honda PS3000HD Instruction Manual

Troubleshooting

PROBLEM
Engine will
not start (see
Engine Owner's
Manual for
further engine
troubleshooting)
No or low
pressure
(initial use)
20.
POSSIBLE CAUSE
No fuel
Pressure builds up after two pulls on
the recoil starter or after initial use
Choke lever in the "No Choke" position
Spark plug wire not attached
Engine switch in OFF position.
Choke lever in the "Choke" position on
a "hot" engine or an engine that has
been exposed to thermal heat for a
long period of time.
Spray wand not in high pressure
Low water supply
Nozzle obstructed
Air in hose
Choke in the "Choke" position
High pressure hose is too long
www.powershot.co.nz
SOLUTION
Add fresh fuel
Squeeze gun trigger to relieve pressure
Move choke to the "Choke" position
Attach spark plug wire
Place engine switch in ON position.
Move choke to the "No Choke"position.
See How to Use Spray Wand instructions
in the Operation Section
Water supply must be at least
5 L/min @ 20psi
Repair leak. Apply sealant tape if necessary
See Nozzle Cleaning instructions in the
Maintenance section
Water Inlet Filter paragraph in the Mainte-
nance section for the correct procedure
Turn off the engine, then the water source.
Disconnect the water source from the pump
inlet and turn the water source on to remove
all air from the hose. When there
is a steady stream of water present, turn
water source off. Re-connect water source
to pump inlet and turn on water source.
Squeeze trigger to remove remaining air
Move choke to the "No Choke" position
Use high pressure hose under 100 feet
(30 m)