Storage; Accessories; Service Information - Honda PS3000HD Instruction Manual

2. Pull trigger on gun
handle to relieve any
water pressure.
3. Disconnect the spray
wand from the gun.
nozzle (K) from spray
wand. Remove any
obstructions with nozzle
cleaning tool provided
loosened particles for 30 seconds.
6. Reassemble the nozzle to the wand.
7. Reconnect spray wand to gun and turn on water
supply.
8. Start pressure washer and place spray wand into
high pressure setting to test.
Clean the Water Inlet Filter
and cleaned if necessary.
end and removing it from
water inlet of pump.
with water on both sides.
inlet of pump. (Convex
side faces out.)
NOTE: Do not operate the pressure washer without

Storage

Engine
Consult the Engine Owner's Manual for manufac-
turer's recommendations for storage.
Pump
The manufacturer recommends using regular anti-
freeze when storing the unit for more than 30 days
and/or when freezing temperatures are expected.
water mix and use a short length of hose to suck the
mixture into the pump while running. Turn machine
off immediately as soon as bucket is empty.
NOTE: Using anti-freeze helps provide proper lubri-
cation to the internal seals of the pump regardless of
temperature or environment.
Pressure Washer
1. Drain all water from high pressure hose and wrap
it onto hose wrap.
2. Drain all water from the spray gun and wand
by holding spray gun in a vertical position with
nozzle end pointing down and squeezing trigger.
Store in gun holder.
3. Wrap up and secure detergent siphon hose so it
is protected from damage.

Accessories

See page 23 for a the Powershot range of
accessories.
NOTE: The use of any other accessory not recom-
mended for use with this tool could be hazardous.
Use only accessories rated equal to or greater than
the rating of the pressure washer.

Service Information

Please contact our customer service department at
www.powershot.co.nz or call 0800 387 678.
www.powershot.co.nz
DANGER!
replacement spray wands or guns with this
pressure washer, DO NOT use a spray wand
and/or spray gun/ wand combination that is
shorter in length than what was provided with
this pressure washer as measured from the
nozzle end of the wand to the gun trigger.
19.