Maintenance - Honda PS3000HD Instruction Manual

NOTE: Failure to release system pressure will
prevent removal of high pressure hose from spray
gun or pump connection.
5. See Storage section in this manual for proper
storage procedures.

Maintenance

WARNING! Risk of burn hazard. When per-
forming maintenance, you may be exposed to
hot surfaces, water pressure or moving parts
that can cause serious injury or death.
WARNING!
disconnect, spark plug wire, let the engine
cool and release all water pressure before
performing any maintenance or repair.
performing maintenance.
pressure washer, a routine maintenance schedule
should be prepared and followed. If the pressure
washer is used in unusual conditions, such as high-
temperatures or dusty conditions, more frequent
maintenance checks will be required.
Engine
Consult the Engine Owner's Manual for the
manufacturer's recommendations for any and all
maintenance.
NOTE: The engine drain plug is located at the rear
of the unit.
The Pump
NOTE:
operation and every 100 hours thereafter, or every
3 months.
18.
To Check Oil
The oil level should come to the dot in the middle of
the sight glass (AA).
How To Change Pump Oil
2. Place a container under pump oil drain plug (CC).
3. Remove pump oil drain plug.
Tighten securely.
oil.
If there is a problem with the pump contact us at
www.powershot.co.nz.
Connections
Connections on pressure washer hoses, gun and
spray wand should be cleaned regularly and
lubricated with light oil or lithium grease to prevent
leakage and damage to the o-rings.
Nozzle Cleaning
If the nozzle becomes clogged with foreign materials,
such as dirt, excessive pressure may develop. If the
nozzle becomes partially clogged or restricted, the
pump pressure will pulsate. Clean the nozzle im-
mediately using the nozzle kit supplied and
the following instructions:
1. Shut off the pressure washer and turn off the
water supply.
www.powershot.co.nz