Cv Boot Replacement - Polaris Outlaw 500 Service Manual

5. Refit CV joint on interconnecting shaft by tapping with a
plastic hammer on the joint housing. Take care not to
damage threads on the outboard CV joint. The joint is fully
assembled when the snap ring is located in the groove on
the interconnecting shaft.
Tap joint onto shaft
6. Install and tighten large boot clamp with boot clamp pliers.
7. Remove excess grease from the CV joint's external surfaces
and position joint boot over housing, making sure boot is
seated in groove. Position clamp over boot end and make
sure clamp tabs are located in slots.
NOTE: NOTE: Before tightening boot clamp on
inboard joint, make sure any air pressure which may
have built up in joint boot has been released. The air
should be released after the plunging joint has been
centered properly. Tighten boot clamp using boot
clamp pliers.
Tabs face shaft
BODY / STEERING / SUSPENSION

CV Boot Replacement

1. Remove CV joint from end of shaft.
2. Remove boot from shaft.
NOTE: When replacing a damaged boot, check the
grease for contamination by rubbing it between two
fingers. A gritty feel indicates contamination. If the
grease is not contaminated, the boot can be
replaced without cleaning the CV joint.
recommended amount
replacement only (see below).
Installation.
3. Thoroughly clean and dry the CV joint and inspect ball
tracks and cages for wear, cracks or other damage.
NOTE: Shiny areas in ball tracks and on the cage
spheres are normal.
because parts have polished surfaces. Replace CV
joint only if components are cracked, broken, worn
or otherwise unserviceable.
4. Add the recommended amount of grease for CV joint
cleaning to the joint as required. Be sure grease penetrates
all parts of the joint.
5. Refit CV joint on interconnecting shaft by tapping with a
plastic hammer on the joint housing. Take care not to
damage threads on the outboard CV joint. The joint is fully
assembled when the snap ring is located in the groove on
the interconnecting shaft.
6. Add grease through large end of boot.
7. Install a new boot onto the axle shaft and fill the CV joint
and boot with the correct type and amount of grease.
Use the
of grease for boot
Proceed to Boot
Do not replace CV joints
5.29
5