Table of Contents
Advertisement
ADDITIONAL SAFETY RULES
1.
Always use eye and ear protection. Other per-
sonal protective equipment such as dust mask,
gloves, helmet and apron should be worn.
2.
Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
3.
Accessories must be rated for at least the speed
recommended on the tool warning label. Wheels
and other accessories running over rated speed can
fly apart and cause injury. Maximum operating
speed of accessories should be higher than the
highest no load speed marked on the tool's name-
plate.
4.
Check the backing pad carefully for cracks,
damage or deformity before operation. Replace
SAVE THESE INSTRUCTIONS
4
cracked, damaged or deformed pad immedi-
ately.
5.
Check that the workpiece is properly supported.
6.
Hold the tool firmly.
7.
Keep hands away from rotating parts.
8.
Make sure the wool bonnet is not contacting the
workpiece before the switch is turned on.
9.
Do not leave the tool running. Operate the tool
only when hand-held.
10. Do not touch the workpiece immediately after
operation; it may be extremely hot and could
burn your skin.
11. If working place is extremely hot and humid, or
badly polluted by conductive dust, use a short-
circuit breaker (30 mA) to assure operator
safety.
ENB071-2
Advertisement
Table of Contents
