Maintenance - Makita 6952 Instruction Manual

MAINTENANCE

1. Limit mark
1
1. Screwdriver
2. Brush holder cap
ACCESSORIES
CAUTION:
• These accessories or attachments are recommended for use with your Makita tool specified in this manual. The
use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or
attachment for its stated purpose.
If you need any assistance for more details regarding these accessories, ask your local Makita service center.
• Screw bits
CAUTION:
• Always be sure that the tool is switched off and unplugged before
attempting to perform inspection or maintenance.
Replacing carbon brushes
001145
Remove and check the carbon brushes regularly. Replace when they wear
down to the limit mark. Keep the carbon brushes clean and free to slip in the
holders. Both carbon brushes should be replaced at the same time. Use only
identical carbon brushes.
1
Use a screwdriver to remove the brush holder caps. Take out the worn carbon
004357
brushes, insert the new ones and secure the brush holder caps.
2
After replacing brushes, plug in the tool and break in brushes by running tool
with no load for about 10 minutes. Then check the tool while running and elec-
tric brake operation when releasing the switch trigger. If electric brake is not
working well, ask your local Makita service center for repair.
To maintain product SAFETY and RELIABILITY, repairs, any other mainte-
nance or adjustment should be performed by Makita Authorized Service Cent-
ers, always using Makita replacement parts.
7