Makita MRP100 Instruction Manual page 6

Before operation, always make sure that the chip
•
deflector is installed properly.
Set the tool base on the workpiece to be cut without the
bit making any contact. Then turn the tool on and wait
until the bit attains full speed. Lower the tool body and
move the tool forward over the workpiece surface,
keeping the tool base flush and advancing smoothly until
the cutting is complete.
When doing edge cutting, the workpiece surface should
be on the left side of the bit in the feed direction.
4
1
2
3
1. Workpiece
2. Bit revolving direction
3. View from the top of the tool
4. Feed direction
001984
NOTE:
Moving the tool forward too fast may cause a poor
•
quality of cut, or damage to the bit or motor.
Moving the tool forward too slowly may burn and
mar the cut. The proper feed rate will depend on
the bit size, the kind of workpiece and depth of cut.
Before beginning the cut on the actual workpiece, it
is advisable to make a sample cut on a piece of
scrap lumber. This will show exactly how the cut
will look as well as enable you to check
dimensions.
2
1
001985
NOTE:
When using the straight guide or the trimmer guide,
•
be sure to install it on the right side in the feed
direction. This will help to keep it flush with the side
of the workpiece.
2
4
1. Feed direction
3
2. Bit revolving
direction
3. Workpiece
4. Straight guide
4
Straight guide
1
004929
The straight guide is effectively used for straight cuts
when chamfering or grooving.
Install the straight guide on the guide holder with the
wing bolt (B). Insert the guide holder into the holes in the
tool base and tighten the wing bolt (A). To adjust the
distance between the bit and the straight guide, loosen
the wing bolt (B) and turn the fine adjusting screw (1.5
mm or about 1/16" per turn). At the desired distance,
tighten the wing bolt (B) to secure the straight guide in
place.
1
2
3
4
004930
Wider straight guide of desired dimensions may be
made by using the convenient holes in the guide to bolt
on extra pieces of wood.
1
2
55 mm
( 2-3/16" )
3
003684
When using a large diameter bit, attach pieces of wood
to the straight guide which have a thickness of more
than 15 mm (5/8") to prevent the bit from striking the
straight guide.
When cutting, move the tool with the straight guide flush
with the side of the workpiece.
6
1. Straight guide
1. Wing bolt (A)
2. Guide holder
3. Fine adjusting
screw
4. Wing bolt (B)
5. Straight guide
5
1. More than
15mm (5/8")
2. Straight guide
3. Wood
55 mm
( 2-3/16" )