Recording - Panasonic AJ-D250P Operating Instructions Manual

Operation

Recording

1
Set the accidental erasure prevention tab on the cassette tape to "recording," and
insert the tape.
2
Press the STOP button to set the unit to the STOP mode.
3
Check that the REC INH lamp has gone off.
4
Selecting the video and audio input signals and adjusting the audio levels
4-1
4-2
5
Press the PLAY button while holding down the REC button.
The REC and PLAY lamps light and recording commences.
6
Press the STOP button to end the recording.
The recording now ends, and the STOP mode is established.
<Notes>
O If recording prevention signals are included among the input signals, the input signals will not
be recorded properly.
O Check that the SERVO lamp has lighted during recording. The image which is played back
will be disturbed if the lamp is flashing or off.
Selecting the video and audio input signals
1
Connect the signals which are to be recorded.
2
Select the input signals using the INPUT SELECT switch on the front panel.
Adjusting the audio levels
1
Adjust the levels of the audio input signals.
The audio signals are recorded at the proper levels when the level controls
are at their center-click positions.
13