Panasonic KX-TVS50 Installation Manual page 73

833-9626) to order a software upgrade.
From the SYS-PGM NO ? screen:
a)
Enter [116].
b)
Press the NEXT button (SP-PHONE).
c)
Enter the system number ([0] or [1], master/slave). The system displays the ROM
version and the date it was created.
This version must be P231U or higher for Digital Integration to be utilized (both
systems if system connection is used).
2.
Set the date and time using System Program [000].
Date and time are automatically synchronized between the VPS and the Panasonic KX-TD
series telephone systems during initial setup.
3.
Set extension numbering using System Program [003].
4.
Assign the Voice Mail Port. This program tells the PBX which jack will be connected to
the VPS. This allows the PBX to send the proper Digital Integration information to those
ports.
• KX-TVS50/80 (2 ports): assign 1 jack
Note
If you are configuring a 2-cabinet system, all Voice Mail Ports should be assigned to
either the Master or Slave System.
From the SYS-PGM NO ? screen:
a)
Enter [117].
b)
Press the NEXT button (SP-PHONE).
Screen output: M: # # # #
c)
Enter the jack number of the port you will use for the Voice Mail (02 - 64).
d)
Press STORE.
e)
Press END (HOLD) when finished.
Conditions:
5.
Skip this step unless setting flexible numbering.
System Program [118] (Voice Mail Extension Number Assignment) is automatically set.
This program allows you to assign an extension number to each Voice Mail port. Since
the jack connected to the VPS provides 2 extensions, this enables you to assign extension
numbers to each port. You can assign any extension number that is not already assigned
to another port. To reach the VPS, users dial these extension numbers. It is not necessary
to change the default programming for the extensions 165 and 166.
INTEGRATING THE VPS WITH THE PANASONIC KX-TA ANALOG PBX AND KX-TD DIGITAL PBX
4.3 CONNECTING THE KX-TVS50/80 WITH THE PANASONIC KX-TD816, KX-TD1232 AND KX-TD308
Jack 01 cannot be used as a Voice Mail port. A jack
programmed as a Manager Extension (System Program
[006]) cannot be used in this program.
73