How To Use The Batteries; Install And Replace Batteries - Honeywell CN51 User Manual

How to Use the Batteries

Install and Replace Batteries

PrintPAD Series CN70/70e & CN51 User Guide
The printer ships with two batteries installed, but they are not operational.
Before operating the printer, remove the two red battery isolator labels either by
gently pulling the labels out or by lifting the batteries up.
If you are storing your printer for a long period of time or shipping it, reinstall the
battery isolator labels. Both batteries must be installed for your printer to
operate properly.
1 Open the printer by unsnapping the latch on the front of the case.
2 Lift the battery cover upward by pushing the retainer clip inward with your
finger.
3 Lift up the outside end of the battery to remove it.
4 Insert the new batteries. Verify the battery contacts are facing down and are
facing the outside edge of the printer.
5 Close the battery cover by snapping it into place.
Chapter 2 — Printer Basics
Contacts
7