Cleaning - Panasonic EH-TSA3F Operating Instructions Manual

Facial ionic steamer
Table of Contents

Advertisement

Available languages
  • EN

Available languages

Cleaning

Note
Disconnect the power cord from the steamer before cleaning.
Do not wash or soak the appliance in water.
Cleaning inside the main unit
To remove limescale and prevent it from forming,
clean the inside of the steamer using the procedure below.
After using, always let the main unit cool down for
at least 10 minutes.
1. Pour water into the tank up to the 12 mark
(full) and close the water supply cap.
2. Attach the water supply tank to
the main unit.
Push the water supply tank into the main unit
until it clicks.
3. Shake the appliance horizontally
3 to 4 times.
Shake the appliance gently without tilting it.
4. Remove the water supply
tank from the main unit.
5. While pressing the
inclination switch on the
bottom, discard the water
from inside the main unit.
Set the steamer back to the horizontal,
then repeat this 2 or 3 times.
6. Repeat steps 2 to 5 (within
7. Throw out the water in the water supply tank, then
use a towel, etc., to wipe any water droplets off the
main unit and water supply tank.
EN13
EH-TSA3F.indb 13-14
EH-TSA3F.indb 13-14
(Clean once a month.)
Shake with a circular
motion.
Water
outlet
Inclination
switch
) 2 or 3 times.
Cleaning the main unit
(if it seems dirty)
Wipe the appliance with a cloth moistened with soapy
water.
Never use alcohol, thinner, benzine, enamel remover, etc.
Doing so may result in malfunction or part cracks or discoloration.
Cleaning the power cord
(Clean once a month.)
Remove the power plug from the power
outlet and the appliance plug from the
main unit, and then wipe away any dust,
etc., using a dry cloth.
If the lid is off
Line up the hooks in the lid with
the grooves in the steamer's hook
receiver and press in.
Press down on both sides at the same
time from straight above.
If the water supply cap seal detaches
1. Push up the center of the water
supply cap.
Use your index finger to press on the center of
the water supply cap.
2. Line up the angle of the water
supply cap with that of the
water supply cap's packing
and press the packing in.
Click
Water supply cap seal
EN14
2015/08/07 12:02:57
2015/08/07 12:02:57

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents