Disabling Lldp-Med Tlvs - Cisco ASR 920 Series Configuration Manual Ethernet Router

Enabling and Disabling LLDP-MED TLVs
SUMMARY STEPS
1. enable
2. configure terminal
3. interface type number
4. lldp med-tlv-select tlv
5. end
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Device> enable
Step 2
configure terminal
Example:
Device# configure terminal
Step 3 interface type number
Example:
Device(config)# interface Gigabitethernet
0/1
Step 4 lldp med-tlv-select tlv
Example:
Device(config-if)# lldp med-tlv-select
inventory-management
Step 5 end
Example:
Device(config-if)# end

Disabling LLDP-MED TLVs

Perform this task to disable a specific LLDP-MED TLV from a supported interface.
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
342
Using Link Layer Discovery Protocol in Multivendor Networks
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Enters global configuration mode.
Specifies the interface type and number on which to enable
LLDP-MED and enters interface configuration mode.
Enables a specific LLDP-MED TLV on a supported interface.
To disable LLDP-MED TLVs, use the no lldp
Note
med-tlv-select tlv command.
Returns to privileged EXEC mode.