Configuration Examples For G.8032 And Cfm Support For Microwave Adaptive Bandwidth - Cisco ASR 920 Series Configuration Manual Ethernet Router

G.8032 and CFM Support for Microwave Adaptive Bandwidth
Configuration Examples for G.8032 and CFM Support for
Microwave Adaptive Bandwidth
Example: Configuring the Ethernet Microwave Event
In this example, two Ethernet microwave events have been created, mw_ring_sdl1 and mw_ring_sd_2:
Device> enable
Device> configure terminal
Device(config)# event manager applet mw_ring_sd1
Device(config-applet)# event ethernet microwave sd interface gigabitethernet0/0/0 threshold
400
Device(config-applet)# action 1 switch ring g8032 ringA instance 1
Device(config-applet)# exit
Device(config)# event manager applet mw_ring_sd2
Device(config-applet)# event ethernet microwave sd interface gigabitethernet0/0/0 threshold
400
Device(config-applet)# action 1 switch ring g8032 ringA instance 2
Device(config-applet)# exit
In this example, a microwave event has been configured that clears all the signal degradation (SD) events, as
defined by the action switch ring g8032 clear instance all command:
Device> enable
Device> configure terminal
Device(config)# event manager applet mw_ring_clear_sd
Device(config-applet)# event ethernet microwave clear-sd interface gigabitethernet0/0/0
Device(config-applet)# action 1 switch ring g8032 clear ringA instance all
Device(config-applet)# exit
Example: Verifying the Ethernet Microwave Event Configuration
The following is sample output from the show ethernet event microwave status command where
GigabitEthernet interface 0/0/2 has been specified. Use the command to confirm that the configuration is
performing as intended.
Device# show ethernet event microwave status GigabitEthernet 0/0/2
Microwave Bandwidth Status for GigabitEthernet0/0/2
State: SIGNAL_DEGRADED
Hold Time: 0 seconds
Restore Time: 10 seconds
Loss Threshold: 3
Total VSM Receive Count: 1
Total VSM Drop Count: 0
Sender Address 64f6.9d67.a006
State: SIGNAL_DEGRADED
Elapsed time in this state: 00:00:43
Nominal Bandwidth: 600 Mbps
Current Bandwidth: 500 Mbps
Lowest Bandwidth: 500 Mbps
Last VSM Received: Thu Apr 30 11:03:45.493
VSM Receive Count: 1

Configuration Examples for G.8032 and CFM Support for Microwave Adaptive Bandwidth

Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
241