Push Buttons; Figure 1-4: Push Buttons - Honeywell KT 74 Pilot's Manual

1.5

PUSH BUTTONS

Press the IDENT button when ATC instructs you to
IDENT
"Ident" or "Squawk Ident". This activates the SPI pulse in
the transponder replies for 18 seconds. IDENT will
appear in the display.
Pressing the VFR button sets the transponder to the pre-
VFR
programmed VFR code. Pressing the button again
restores the previous squawk code.
Pressing the VFR button while in Flight ID editing mode
changes the Flight ID to the pre-programmed ID set up
during configuration of the transponder.
Pressing the FUNC button provides access to the flight
FUNC
timer, stopwatch, Flight ID entry, ADS-B monitor
(depending on installation) and altitude monitor function.
See section 1.6 below.
The ENT button confirms selection or presented options.
ENT
The numeric buttons are used to change the squawk
0-7
code and as part of the data entry selections.
D201308000036
Rev 0 Dec 2013
© Honeywell International Inc. Do not copy without express permission of Honeywell

Figure 1-4: Push Buttons

KT 74 Pilot's Guide
Operation
Page-1-5