To do...
Enter system view
Enable LLDP globally
Enter Ethernet
interface view
or port group
view
Enable LLDP
Setting the LLDP operating mode
LLDP can operate in one of the following modes.
TxRx mode. A port in this mode sends and receives LLDPDUs.
•
•
Tx mode. A port in this mode only sends LLDPDUs.
Rx mode. A port in this mode only receives LLDPDUs.
•
Disable mode. A port in this mode does not send or receive LLDPDUs.
•
Follow these steps to set the LLDP operating mode:
To do...
Enter system view
Enter Ethernet
interface view
or port group
view
Set the LLDP operating mode
Setting the LLDP re-initialization delay
When LLDP operating mode changes on a port, the port initializes the protocol state machines after a
certain delay. By adjusting the LLDP re-initialization delay, you can avoid frequent initializations caused
by frequent changes to the LLDP operating mode on a port.
Follow these steps to set the LLDP re-initialization delay for ports:
To do...
Enter system view
Set the LLDP re-initialization delay
Enter Layer 2 Ethernet
interface view
Enter port group view
Enter Layer 2 Ethernet
interface view
Enter port group view
Use the command...
system-view
lldp timer reinit-delay delay
Use the command...
system-view
lldp enable
interface interface-type
interface-number
port-group manual
port-group-name
lldp enable
Use the command...
system-view
interface interface-type
interface-number
port-group manual port-group-name
lldp admin-status { disable | rx | tx |
txrx }
171
Remarks
—
Required
By default, LLDP is globally
enabled.
Required
Use either command.
Optional
By default, LLDP is enabled on a
port.
Remarks
—
Required
Use either command.
Optional
TxRx by default
Remarks
—
Optional
2 seconds by default