Mac-Based Vlan Configuration Example - HP A3100-8 v2 SI Configuration Manual

NOTE:
After enabling MAC-based VLAN on the switch, you must configure related authentication settings on the
access authentication server. For more information about 802.1X authentication, see the
Configuration Guide
Follow these steps to configure dynamic MAC-based VLAN:
To do...
Enter system view
Enter
Ethernet
interface
view or port
group view
Configure the link type of the
port(s) as hybrid
Enable MAC-based VLAN

MAC-based VLAN configuration example

Network requirements
• As shown in
room. Laptop 1 and Laptop 2 are used for meetings and might be used in either of the two meeting
rooms.
Different departments own Laptop 1 and Laptop 2. The two departments use VLAN 100 and VLAN
•
200 respectively. Each laptop must be able to access only its own department server, no matter
which meeting room it is used in.
The MAC address of Laptop 1 is 000d-88f8-4e71, and that of Laptop 2 is 0014-222c-aa69.
•
.
Use the command...
system-view
Enter Ethernet interface interface-type
interface view interface-number
Enter port
port-group manual port-group-name
group view
port link-type hybrid
mac-vlan enable
Figure 32, Ethernet 1/0/1 of Device A and Device C are each connected to a meeting
105
Security
Remarks
—
Use either command.
•
The configuration made in
Ethernet interface view applies
only to the current port.
•
The configuration made in port
group view applies to all ports in
the port group.
Required
Required
Disabled by default