Adjusting The Send From Level; Adjusting The Send Level From Aux Channels, Stereo Channels, And Sub Channel To A Matrix Channel (V2.5 And Later); Send From Screen - Yamaha RACK Reference Manual

SEND FROM screen

Allows you to send signals from the each channels.
1
ON button
Determines whether a signal is sent (on) or not sent (off) from the corresponding each
channel.
2
Send pan slider
Adjusts the pan of the input channel signal that is sent.
For AUX 1–8, this slider is only displayed if the signal type is set to stereo.
Not displayed for MATRIX 1–4 or FX1L–FX2R.
3
Send level slider
Determines the amount of signal sent from the corresponding each channel.
4
Pre button
Allows you to select whether the pre-fader or post-fader signal is sent from the
corresponding input channel.
On: Before the fader
Off: After the fader
Not displayed for MATRIX 1–4.

Adjusting the SEND FROM level

1. Touch the ON button for the input channels
that you want to send.
2. Touch the send pan slider, and then use the
[TOUCH AND TURN] knob to adjust the pan
of the input channel signal that is sent.
3. Drag the send level sliders to adjust the
amount of input channel signal that is sent.
Adjusting the send level from AUX channels, STEREO channels, and SUB
channel to a MATRIX channel (V2.5 and later)
1. Touch the ON button for the AUX channel, STEREO channel, or SUB channel that
you want to send. (It is turned on by default.)
2. Drag the send level sliders to adjust the amount of AUX channel, STEREO channel,
and SUB channel signal that is sent.
NOTE
• You can send the post-on signal of an AUX channel, STEREO channel, or SUB channel to a MATRIX
channel.
• Left and right channel SEND levels can be adjusted independently for stereo channels such as AUX 9/
10 and STEREO.
- 74 -
Configuration screens
ON button
Send pan slider
Send level slider
Pre button
ON button
Send level slider
TF Series
Reference Manual