Insert Block; Stereo Aux Send 1~12 Block; Input Channel Section; Send Level And Pan Controls - Yamaha PM 5000 Owner's Manual

Insert Block

These switches are used to determine whether and where
external processing gear connected to the rear-panel
INSERT IN and OUT connectors will be inserted into
the channel signal path.
)

9 Insert [ON] Switch

Turns channel insert on or off. When the [ON] switch is
engaged an external equipment connected to the rear-
panel INSERT IN connectors is inserted into the
channel's signal path. The [PRE] switch (below)
determines whether the insert is pre- or post-EQ.
) [PRE] Switch
Determines whether the channel's INSERT IN and OUT
connectors insert the externally connected gear before or
after the channel EQ stage. When the switch is off the
insert is post-EQ. When on (when the indicator is lit) the
insert is pre-EQ.
NOT E
The channel signal appears at the rear-panel INSERT OUT
connector whether the INSERT [ON] switch is engaged or not.

Stereo Aux Send 1~12 Block

The controls in this block determine
the levels at which the channel signal is
sent to the console's 12 stereo aux
buses.

! Send Level and Pan Controls

The inner controls adjust send level (0
dB at approximately 2 o'clock), and
9
the outer controls adjust pan for mono
modules or balance for stereo modules.
@ [ON] Switch
When an [ON] switch is engaged the
send to the corresponding aux bus is
active.
# [PRE] Switch
When this switch is engaged the pre-
fader signal is sent to the
corresponding aux bus. When off, the
post-fader signal is sent to the aux bus.
(mono modules)
Send Level and Balance
Controls (stereo modules)

Input Channel Section

!
@
#
17