Panasonic SJ-MR100 Operating Instructions Manual page 24

A
24
ENGLISH
Recording
∫ Adding track marks
Digital recording
≥When recording from CD
The track marks are put onto the MD as
they are found on the CD. Each time a new
track starts on the CD, the number of the
tracks on the MD increases by one.
(Track marks may not be inserted accu-
rately in some cases.)
≥When recording from digital sources
other than CDs
2 seconds of silence is determined as the
division between tracks and a track mark is
added.
To add track marks manually
See page 28.
Analogue recording
2 seconds of silence is determined as the di-
vision between tracks and a track mark is
added.
To add track marks manually
See page 28.
Note.
Track marks will not be added if the space
between tracks is short or if there is noise in
the space. Track marks may be added in
error if there is a silent or especially quiet
portion in a track. Use the editing functions
after recording to add and remove track
marks. (See page 48–56.)
Recording with a microphone
Add track marks manually or have the unit
add the marks at selected intervals.
(See page 28.)
∫ Making good recordings
Power the unit with the AC adaptor while
recording. If you intend to use batteries,
recharge the rechargeable battery fully and
use a new dry cell battery.
≥If the unit turns off while recording, or when
"UTOC Writing" is on the display ("WRITE"
on the remote control), the recording will
not be correctly recorded onto the disc. A
≥"DISC ERROR" may appear on the display
if the unit turns off while "UTOC Writing" is
on the display.