Honeywell DOMONIAL User Manual page 12

ARMED IN 20
SECONDS
If your system is set up to arm once the final door has been closed, close this door to complete
the arming process. Otherwise, you must leave the premises before the end of the exit delay.
The icon confirms arming of the Annex set.
The screen clears after a few seconds.
NB: Depending on the configuration of your system, you may not have an Annex. In this case, the
message INACTIVE FUNCTION will be displayed on the TCU screen.
DISARMING USING YOUR CODE OR TAG
Note that the disarming process may vary, depending on your system configuration. Your installer may
set an entry delay of several seconds.
Enter your 4 to 6-digit user code or present your TAG.
The disarming tone is emitted by the keypad and by the panel siren (if set up).
Depending on the configuration of your keypad, this will disarm the Total Set or the
entire system. In the latter case, the annex set might need to be rearmed.
Disarming the system will also stop the sirens if you have accidentally triggered an
alarm.
In certain circumstances, you may wish to cancel the arming process before the system
has finished arming. In this case, press
Stopping the siren does not interrupt the transmission to the alarm company.
PERSONAL ATTACK*
* The activation of this function is optional and can be performed at installation.
If set up on your system, you can send an alarm at any time.
Press the Total
Depending on the configuration of your keypad, this action will result in:
An alarm being sent to the alarm company.
The siren being triggered.
to disarm.
and Partial arming keys simultaneously.
12