Troubleshooting - Philips DCM2055 User Manual

8 Troubleshooting

Warning
‡
Never remove the casing of this device.
To keep the warranty valid, never try to repair
the system yourself.
If you encounter problems when using this
device, check the following points before
UHTXHVWLQJ VHUYLFH ,I WKH SUREOHP UHPDLQV
unsolved, go to the Philips Web page
(www.philips.com/support). When you contact
Philips, make sure that the device is nearby
and the model number and serial number are
available.
No power
‡ Ensure that the AC power plug of the unit
is connected properly.
‡ Ensure that there is power at the AC
outlet.
‡ To save power, the system switches off
automatically 15 minutes after track
play reaches the end and no control is
operated.
No sound or poor sound
‡ Adjust the volume.
‡ Disconnect the headphones.
No response from the unit
‡ Disconnect and reconnect the AC power
plug, then turn on the unit again.
‡ As a power-saving feature, the system
switches off automatically 15 minutes after
track play reaches the end and no control
is operated.
Remote control does not work
‡ %HIRUH \RX SUHVV DQ\ IXQFWLRQ EXWWRQ ÀUVW
select the correct source with the remote
control instead of the main unit.
‡ Reduce the distance between the remote
control and the unit.
‡ Insert the battery with its polarities (+/–
signs) aligned as indicated.
‡ Replace the battery.
20 EN
Downloaded From Disc-Player.com Philips Manuals
‡ Aim the remote control directly at the
sensor on the front of the unit.
No disc detected
‡ Insert a disc.
‡ Check if the disc is inserted upside down.
‡ Wait until the moisture condensation at
the lens has cleared.
‡ Replace or clean the disc.
‡ 8VH D ÀQDOL]HG &' RU FRUUHFW IRUPDW GLVF
&DQQRW GLVSOD\ VRPH ÀOHV LQ 86% GHYLFH
‡ 7KH QXPEHU RI IROGHUV RU ÀOHV LQ WKH 86%
device has exceeded a certain limit. This
phenomenon is not a malfunction.
‡ 7KH IRUPDWV RI WKHVH ÀOHV DUH QRW
supported.
USB device not supported
‡ The USB device is incompatible with the
unit. Try another one.
Poor radio reception
‡ Increase the distance between the unit and
your TV or VCR.
‡ Fully extend the FM antenna.
Timer does not work
‡ Set the clock correctly.
‡ Switch on the timer.
Clock/timer setting erased
‡ Power has been interrupted or the power
cord has been disconnected.
‡ Reset the clock/timer.