Inspection And Repairs; Electrical Safety - Black & Decker SM700 Manual

ENGLISH
After use
• Switch off, remove the plug from the
socket and let the appliance cool down
before leaving it unattended and before
changing, cleaning or inspecting any
parts of the appliance.
• When not in use, the appliance should
be stored in a dry place. Children should
not have access to stored appliances.

Inspection and repairs

• Before use, check the appliance for
damaged or defective parts. Check for
breakage of parts, damage to switches
and any other conditions that may
affect its operation.
• Do not use the appliance if any part is
damaged or defective.
• Have any damaged or defective parts
repaired or replaced by an authorised
repair agent.
• Before use, check the power supply
cord for signs of damage, ageing and
wear.
• Do not use the appliance if the power
supply cord or mains plug is damaged
or defective.
• If the power supply cord or mains plug
is damaged or defective it must be
repaired by an authorised repair agent
in order to avoid a hazard. Do not cut
the power supply cord and do not
attempt to repair it yourself.
• Never attempt to remove or replace any
parts other than those specified in this
manual.
6
(Original instructions)
Additional safety instructions for
Food Mixers
Warning! Do not place near a hot Gas or
electric oven.
• Do not Immerse Mixer, Base, Cord or
Plug in any liquid.
• Allow all moving parts of the appliance
to come to a stop before approaching.
• Always use on a clean work surface and
clean the surface thoroughly after use.
• Allow the appliance to cool before
storing.
• Keep hands, long hair and loose
clothing away from the beaters.
• Always take care when handling the
sharp cutting blades when emptying
the bowl and during cleaning.
• Be careful if hot liquid is poured into the
blender as it can be ejected out of the
appliance due to a sudden steaming.

Electrical safety

This tool is double insulated;
therefore no earth wire is required.
Always check that the power supply
corresponds to the voltage on the
rating plate.
• If the supply cord is damaged, it must
be replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.