Makita 2414EN Technical Information page 6

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -3. Vise Section (cont.)
ASSEMBLING
Assemble by reversing the Disassembly procedure. (Refer to Fig. 7)
Note: Align the ring of Chain to the square projection of Screw guide when securing Chain with M8x30 Pan head screw.
(Fig. 8)
Fig. 8
[3]-4. Base
DISASSEMBLING
(1) Compression spring 45 is removed as drawn in Fig. 9.
Fig. 9
1. Secure the motor section
to hook Chain on Hanger
at the rear side of Handle.
Chain
4. While holding the base section with your knees, push Spring
holder by both hands toward Spring room of Gear housing.
Spring holder is now removed from M10 Hex bolt.
Compression
spring 45
Spring
holder
M10 Hex bolt
2. Remove M6x12 Hex socket
head bolt, Spring washer 6
and M6 Hex nut from the
hole near the hinge.
Spring washer 6
M6 Hex nut
M6x12 Hex socket
head bolt
Compression
spring 45
Spring
holder
M10 Hex bolt
M8x30 Pan head screw
Ring of Chain
Square projection on Screw guide
3. Lift up the motor section until Safety
cover touches Spark guard.
Note: Do not remove Spark guard in this
step because this guard functions as a
stopper for avoiding accidental popping
of Compression spring 45.
Spark guard
5. Remove Spring holder and Compression
spring 45 from the spring room of Gear
housing.
Compression
spring 45
Spring holder
P 6/ 9