Operation - Black & Decker 3339-220 3.0 H.P Instruction Manual

154708/3339-220 rtr 5/17/02
Using the Turret Stop for Sequential Routing Depth
Settings
TURN OFF AND UNPLUG ROUTER.
It is recommended that particularly deep grooves be cut with several passes
rather than one deep pass. In order to do this and still maintain accuracy of
depth when the job is finished, perform the following procedure.
1. Set the final desired routing depth as instructed above. For the
purpose of this discussion, assume that the desired depth is 1/2".
2. With a depth of 1/2" set on the shortest screw in the turret stop, adjust
the second shortest screw to a point about halfway between the bottom
of the knurled knob and the top of the shortest screw, as shown in
Figure 10.
3. Leave the vernier setting alone and turn the adjusted second shortest
screw into position under the depth stop bar.
4. Make your first cut at this setting.
2:36 PM Page 7
Figure 10
SHORTEST SCREW
TURRET STOP
Figure 11
A
B
C
5. Rotate the turret stop so that the shortest screw is directly under the
depth stop bar and make your final cut.
NOTE: The third screw in the turret stop is provided if your cut is even deep-
er and you want to make three cuts to achieve the final depth, or set final
depth for multiple cuts at one time.

Operation

After setting the cutting depth as described, locate the router such that the
bit is directly over the place you will be cutting. With the router running,
lower the unit smoothly down into the workpiece. (DO NOT JAM THE
ROUTER DOWN). When the tool reaches the pre-set depth, depress the
plunge lock lever. When you have finished routing, raise the lever and let the
spring lift the router directly out of the workpiece.
All common routing tasks can be performed with ease with the plunge cut router:
Grooving, rabbeting, recessing, veining, and profiling on all types of wood and
plastic.
7
D
Figure 12