Honeywell Excel 50 User Manual page 50

L W
ON
EN2B-0137GE51 R0216
Bus Using the arrow keys, move the cursor to 'LON-Bus' and confirm with ENTER. The
ORKS
following screen appears:
LON-Bus Config.
Contr. Neuron ID
<
neuron ID number
Bus ID
This screen displays the unique identification number for the Neuron processor in
the controller.
Using the arrow keys, move the cursor to 'BACK'. Confirm with ENTER.
IMPORTANT
The bus ID is a non-unique number (i.e. different Excel 500 controllers can
have the same bus ID in common) between 0 and 99 (inclusive) which the
user can edit after a reset during the controller's start-up sequence or by
changing the configuration property nciXL500BusSetup. The factory default
is "0".
Modem Communication
confirm with ENTER. If modem communication has not yet been enabled, the
following screen appears:
Config. Interf.
Enable Rem. B.
This screen allows the user to enable modem communication. If you select 'Enable
Rem. B.', you will be asked to wait while the firmware is restarted. If modem
communication is already enabled, the following screen will appear:
Config. Interf.
Config. Rem. B.
Disable Rem. B.
If 'Config. Interf.' Is selected, the following screen appears:
Modem Config.
Baudrate:
GSM PIN ********
Reset Modm ›NEXT
NOTE: GSM communication is not supported.
Using the arrow keys, move the cursor to
— 'Baudrate' to set the baud rate for the modem/ISDN terminal adapter.
— 'Reset Modem' to return modem to factory settings, erasing any custom modem
initialization. See section "Remote Communications" of the Excel 50 Controller
Installation Instructions, EN1B-101, for more information.
Using the arrow keys, move the cursor to the appropriate value fields. Use the '+'
and '–' keys to change the fields.
Or select 'Config. Rem. B.' to go to the next screen:
Appl. Mem. Size
128 KB
Rem. Trend Buf.:
104 Entr. ›BACK
>
›BACK
Using the arrow keys, move the cursor to 'Modem' and
9600
RESTART
50
EXCEL 50 - USER GUIDE