Telephone Type Assignment - NEC Xen IPK Programming Manual

Xen IPK

Telephone Type Assignment

General Description
Use this Memory Block to specify the type of device that is connected to an ESI port.
Display
ESI
Port No.
(01~96)
0 1 : T E L
T I M E
Settings
LK 1 LK 2
DSS Con-
Non Telephone
LK 5 LK 6
Digital Voice
Programming Procedures
1 Go off-line.
2 Press LK7 + LK2 to access the Memory Block.
To change data, press the corresponding CO/PBX line key.
3
Note: Use the following to enter data:
R
: Next Tel Port No.
N
4 Press to write the data.
P
Press to go back on-line.
5
Related Programming
M.B. Number
Refer to Chapter 2, Guide to Feature Programming.
N
1. Only Multiline Terminals can be assigned to ports 01 and 02.
2. A maximum of four Attendant Add-On Consoles can be installed in the system.
3. A maximum of eight SLT(1)-U( ) ADP adaptors can be installed in the system.
4. A maximum of eight Digital Voice Mail ports are available.
5. When assigning SLT adaptors or Digital Voice Mail ports, Memory Block , 4-10 , Station Number Assignment must be
reassigned also.
6. If more than one DSS console is assigned, make sure that the order of assignment is as follows:
DSS1 must always be a lower port than DSS2
DSS2 must be a lower port than DSS 3
DSS3 must be a lower port than DSS 4
7-2, Telephone Type Assignment
Setting Data
D I S P L A Y
LK 3 LK 4
SLT
sole Adapter
The shaded area indicates
the default setting.
LK 7 LK 8
Mail
Memory Block Name
Programming Manual
System Mode
7
Telephone
2
Data No.
—
PC Programming
+ BS
DRAFT 3
Chapter 1 – 507
7-2