Rear Wheel (For Non-Abs Models) - Yamaha F DIVERSION XJ6F Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
4. Take the motorcycle off the cen-
terstand so that the front wheel is
on the ground, and then put the
sidestand down.
5. Tighten the wheel axle, the front
wheel axle pinch bolt and the
brake caliper bolts to the specified
torques.
Tightening torques:
Wheel axle:
65 Nm (6.5 m·kgf, 47 ft·lbf)
Front wheel axle pinch bolt:
19 Nm (1.9 m·kgf, 14 ft·lbf)
6
Brake caliper bolt:
40 Nm (4.0 m·kgf, 29 ft·lbf)
6. Push down hard on the handlebar
several times to check for proper
fork operation.
Rear wheel (for non-ABS
models)
WARNING
For the ABS model, have a Yamaha
dealer remove and install the wheel.
To remove the rear wheel
WARNING
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
1. Loosen the locknut and drive
chain slack adjusting nut on each
side of the swingarm.
2. Loosen the axle nut.
6-42
EAU44802
1
EWA14841
EAU56671
1. Axle nut
2. Drive chain slack adjusting nut
3. Locknut
EWA10822
3. Place the motorcycle on the cen-
terstand.
4. Remove the axle nut.
5. Push the wheel forward, and then
remove the drive chain from the
rear sprocket.
2
3