Rear Wheel (For Non-Abs Models) - Yamaha Fazer 8 2014 Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
1
2
1. Brake caliper bolt
2. Brake caliper
5. Pull the wheel axle out, and then
6
remove the wheel.
To install the front wheel
1. Lift the wheel up between the fork
legs.
2. Insert the wheel axle.
3. Lower the front wheel so that it is
on the ground, and then put the
sidestand down.
4. Install the brake calipers by install-
ing the bolts.
TIP
Make sure that there is enough space
between the brake pads before install-
ing the brake calipers onto the brake
discs.
5. Install the brake hose holders by
installing the bolt and nut.
6. Tighten the brake caliper bolts and
the brake hose holder bolts to the
specified torques.
Tightening torques:
Brake caliper bolt:
40 Nm (4.0 m·kgf, 29 ft·lbf)
Brake hose holder bolt:
6 Nm (0.6 m·kgf, 4.3 ft·lbf)
7. Tighten the wheel axle, and then
the wheel axle pinch bolt to the
specified torques.
Tightening torques:
Wheel axle:
65 Nm (6.5 m·kgf, 47 ft·lbf)
Front wheel axle pinch bolt:
23 Nm (2.3 m·kgf, 17 ft·lbf)
8. Push down hard on the handlebar
several times to check for proper
fork operation.
6-42
Rear wheel (for non-ABS
models)
WARNING
For the ABS model, have a Yamaha
dealer remove and install the wheel.
To remove the rear wheel
WARNING
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
1. Loosen the axle nut.
1
1. Axle nut
EAU44802
EWA14841
EAU56701
EWA10822