Kaaz(R) Manual
Feed
Head
Reassembly
2.
1.
Prepare for reassembly by placing the spring on
the drum as shown in Figure 145.
SPOOL
SPRING
EYELET
3.
4.
5.
6.
Thread one eyelet onto each end of the trimmer
line and position the spool (with the small flange
toward the spool) above the drum.
Push the eyelets into the slots in the drum making
sure
that
they
bottom out.
Place the spool and drum assembly on the cutter
head shaft with the spool facing the shield.
Secure with the knob by turning counterclockwise.
IMPORTANT Make sure the ratchets on the
spool
flange line up with the recesses in the
drum before tightening.
Adjust the length of the line
so that it does not
extend beyond the flange edge of the shield.
Figure 145