Head Disassembly; Inspection; Reassembly - Toro 51643 Service Manual

Leeco(R) Manual Feed Head Spool Installation
(cont'd)
Figure 139
4. Cut off any excess line so that
it
does not strike the
shield when fully extended.
Leeco(R) Manual Feed Head Disassembly
1. Remove the head assembly by inserting a medium
blade screwdriver into one of the two slots in the
top of the shield. See Figure 140. This prevents the
head from rotating.
SCREWDRIVER
Figure 140
2.
Turn the head clockwise to loosen and remove the
head assembly from the drive shaft.
3. Hold the drum stationary while turning the knob
clockwise to remove the knob. Hold onto the knob
firmly as
it
is under slight spring pressure. Remove
the knob, spring and spool.
Leeco(R) Manual Feed Head Inspection
1. Inspect the drum, spool and knob for any damage
which may impair their operation. Replace as
required.
2.
Inspect the eyelets for wear and sharp edges.
Replace if necessary. They can be replaced
individually.
3 .
Remove the cutter head shaft from the drum and
inspect for damage. Replace if necessary.
Leeco(R) Manual Feed Head Reassembly
1.
Push the
two
eyelets into the slots provided in the
drum making sure that they bottom out.
2. Install the cutter head shaft into the drum as shown
in Figure 141.
ADAPTER
SHAFT
Figure 141
3. Wind line onto spool
as
described under Leeco(R)
Manual Line Feed Head Line Replacement,
page 58.
4.
Install the spool and line assembly into the drum,
threading one line through each of the eyelets.
See
Figure 142.
59